5. OPERATING CONTROLS - INSTRUCTIONS

1. ON/OFF CONTROL SWITCH
To START, move the switch to I. To STOP switch to STOP.

2. FUEL PRIMER BULB
Makes starting easy. Press bulb three/four times before using recoil starter handle.

3. CHOKE LEVER
Pull out to start and push in after motor fires.







4. RECOIL STARTER
Start Motor by pulling the recoil starter handle. Always allow the Starter Cord to return to its position under control and DO NOT allow it to fly back.

5. THROTTLE TRIGGER
When the throttle trigger is squeezed the Motor speed increases.

6. HALF SPEED LEVER
To operate hold down the lever, then release the trigger and it will hold in position.

7. FORWARD/REVERSE CONTROL KNOB
This has three positions: marked N, F and R
    N - Neutral
    F - Clockwise Rotation
    R - Anti-clockwise Rotation
To engage turn fully 90 degrees from the Neutral position. The gears are stationary when the Motor is idling at tick over speed. Select the gear required. If it will not engage, gently squeeze the throttle trigger so the gear parts move slightly.

8. SOCKET SQUARE DRIVE
Standard 1 inch Square Drive. The Accessory is secured to the Square Drive by a Rubber Ring and a 5mm dia Bright Steel Pin or other suitable retaining device. If the Pin breaks or bends examine both Accessory and Square Drive for possible wear.
Worn Accessories damage the Square Drive. A worn Square Drive damages accessories and both create extra vibration.

9. TORQUE SETTING LEVER
This has five positions allowing a range of torques to be selected. LOW settings normally 500Nm (350 Ft/lbs) and HIGH setting 1800Nm (1,325 Ft/lbs). For tightening fasteners and drilling use one of the LOW settings and for removing Fasteners a HIGH one.

10.OIL FILLER PLUG
Use for filling, draining and indicating Gearbox oil level.

11.FUEL FILLER CAP
Remove carefully when refilling the Fuel Tank.

12. DE-COMPRESSION BUTTON
To assist in easy starting push in before starting. Comes out automatically when motor starts.